Onkyo Before Using the TX-SR501/TX-SR501E, Setting the Voltage Selector Worldwide model only

Before Using the TX-SR501/TX-SR501E

Setting the Voltage Selector (Worldwide model only)

The Worldwide model has a voltage selector for compatibil- ity with power systems around the world. Before you plug in this model, make sure that the voltage selector is set to the correct voltage for your area. If it isn’t, use a small screw- driver to set it as appropriate. For example, if the voltage in your area is 120 volts (V), set the selector to “120V.” And if it’s between 220 and 230 volts (V), set it to “220–230V.”

COMPONENT VIDEO	ANTENNA	FM
VIDEO 1 / 2 / 3 DVD IN OUT	AM
IN		75
Y						AC OUTLET
		FRONT	FRONT	SURROUND	CENTER	SWITCHED
		SPEAKERS B	SPEAKERS A	SPEAKERS	SPEAKER	100W MAX.
PB			L	L

	PR	VIDEO 2	VIDEO 1		DVD	MONITOR
		IN	OUT	IN	IN	OUT	L
DIGITAL INPUT		REMOTE
		CONTROL				VIDEO	R	R
OPTICAL	COAXIAL
2	1

R

S VIDEO	VOLTAGE
	SELECTOR

IN	OUT	IN	IN	OUT	IN	FRONT	SURR	CENTER	SURROUND BACK	120V
									SPEAKER
L			L				L
SUBWOOFER										220-230V
PRE OUT
R			R				R
								SUB
CD		TAPE	VIDEO 2	VIDEO 1			DVD	WOOFER

VOLTAGE

SELECTOR

120V

220-230V

•If you intend not to use the remote controller for a long time, remove the batteries to prevent possible leakage and corrosion.

•Flat batteries should be removed as soon as possible to pre- vent possible leakage and corrosion.

Using the Remote Controller

To use the remote controller, point it at the TX-SR501/ TX-SR501E’s remote control sensor, as shown below. The TX-SR501/TX-SR501E’s STANDBY indicator flashes while a signal is being received from the remote controller.

Remote control sensor

TX-SR501/TX-SR501E

Standby indicator

30˚

30˚

Installing the Batteries

1 Open the battery compartment, as shown.

2	Insert the two supplied batteries (AA/R6) in
	accordance with the polarity diagram inside
	the battery compartment.

3 Close the battery compartment.

Notes:

•The supplied batteries should last for about six months, although this will vary with usage.

•If the remote controller doesn’t work reliably, try replacing both batteries.

•Don’t mix new and old batteries, or different types of bat- teries.

Notes:

•The remote controller may not work reliably if the TX-SR501/TX-SR501E is subjected to bright light, such as direct sunlight or inverter-type fluorescent lights. Keep this in mind when installing the TX-SR501/TX-SR501E.

•If another remote controller of the same type is used in the same room, or the TX-SR501/TX-SR501E is installed close to equipment that uses infrared rays, the remote con- troller may not work reliably.

•Don’t put anything, such as a book, on the remote control- ler, because the buttons may be pressed inadvertently, thereby draining the batteries.

•The remote controller may not work reliably if the TX-SR501/TX-SR501E is installed in a rack behind col- ored glass doors. Keep this in mind when installing the TX-SR501/TX-SR501E.

•The remote controller will not work if there’s an obstacle between it and the TX-SR501/TX-SR501E’s remote con- trol sensor.

5