Onkyo TX-SR600/600E instruction manual Connections TX-SR700/700E, Connecting a DVD player DVD

Connections (TX-SR700/700E)

Connecting a DVD Player with 2-Channel (L/R) Audio Output

ANTENNA

FM 75

DIGITAL INPUT

OPTICAL

2 1

IN

L

SUBWOOFER

PRE OUT

R

CD

AM

DIGITAL	VIDEO 3
OUTPUT COAXIAL	IN
OPTICAL

COAXIAL

DIGITAL

INPUT

OUT IN IN

TAPE VIDEO 3

RL PHONO IN

VIDEO 2

OUT IN

OUT IN

VIDEO 2

GND

COMPONENT VIDEO

	INPUT 2	INPUT 1	OUTPUT
			Y
			PB
				REMOTE
			PR CONTROL
VIDEO 1		DVD	MONITOR	ZONE 2
OUT	IN	IN	OUT
			V	12V
				TRIGGE
				OUT
			S	IR
				IN
OUT	IN	FRONT	SURR CENTER
			L
			R
VIDEO 1			SUB
			WOOFER

DVD

Y

PB Component video output

PR

Video ouput

S video output

4. DVD player (DVD)

L (white)

Analog audio output R (red)

Digital audio output (coaxial)

: Signal flow

4. Connecting a DVD player (DVD)

Using an RCA video cable, connect the video output jack (composite) of the DVD player to the DVD VIDEO IN jack of the TX-SR700/ 700E. Or if the DVD player has an S video output jack, connect it to the DVD S VIDEO IN jack with an S video cable. Or if the device has component video outputs, connect them to the COMPONENT VIDEO INPUT 1 or 2 jacks on the TX-SR700/700E.

With the initial settings of the TX-SR700/700E, the DVD input source is set for the COMPONENT VIDEO INPUT 1 jacks.

If you connect the DVD player to the COMPONENT VIDEO INPUT 2 jacks, this must be changed at “Input Setup” → “Component Video” (see page 54).

Using an RCA audio connection cable, connect the audio output jacks of the DVD player to the DVD FRONT L/R jacks of the TX- SR700/700E. Make sure that you properly connect the left channel to the L jack and the right channel to the R jack.

If the device has a 5.1-channel output, connect the DVD FRONT L/ R, SURR L/R, CENTER, and SUBWOOFER (5.1-channel input) jacks of the TX-SR700/700E to the 5.1-channel output jacks of the DVD player. Make sure that you properly connect the left channels to the L jacks and the right channels to the R jacks.

If the device has a digital output, connect it to either the DIGITAL INPUT COAXIAL jack or the DIGITAL INPUT OPTICAL jack of the TX-SR700/700E depending on the type of connector on the DVD player.

With the initial settings of the TX-SR700/700E, the DVD input source is set for digital input at the COAXIAL jack (COAX).

If the digital connection is made at a different jack, this must be changed at “Input Setup” → “Digital Input” (see page 53).

Note:

If the DVD player has both 5.1-channel audio outputs and 2-channel audio outputs, and you want to connect the DVD player only using the FRONT L/R jacks on the TX-SR700/700E, use the 2-channel audio output jacks on the DVD player.

18