First Time
Changing the Input Display |
| Minimum Speaker Impedance |
If you connect an 
the TAPE IN/OUT or VIDEO 3 IN jacks, for 
to work properly, you must change this setting.
This setting can only be changed on the AV receiver.
|
|
|
|
|
|
|
|
|
|
| MASTER VOLUME |
STANDBY/ON |
|
|
|
|
|
|
|
|
|
|
|
| STANDBY |
|
|
|
|
|
|
|
|
|
|
| ZONE 2 |
|
|
|
|
|
|
|
|
|
|
POWER |
|
|
|
|
|
|
|
|
|
|
|
ON OFF |
|
|
|
|
|
|
|
|
|
|
|
PURE AUDIO | MULTI CH | DVD | VIDEO 1 | VIDEO 2 | VIDEO 3 | VIDEO 4 | TAPE | TUNER | CD | PHONO | DISPLAY |
PUSH TO OPEN
|
| 1, 2 | 1, 2 |
1 |
| Press the [TAPE] or [VIDEO 3] | |
TAPE | input selector button so that | ||
|
| ||
|
| “TAPE” or “VIDEO3” appears on | |
|
| the display. | |
| or |
|
|
| VIDEO 3 |
|
|
If you change this setting, you must run the automatic speaker setup again (see page 40).
If the impedance of any speaker is 4 ohms or more but less than 6, set the Minimum Speaker Impedance to 4 ohms.
Note:
Before you change this setting, turn down the volume.
1 | RECEIVER | Press the [RECEIVER] button, | |
followed by the [SETUP] button. | |||
|
|
The main menu appears onscreen.
2 | Use the Up and Down [ ]/[ ] |
| buttons to select “3. Speaker |
| Setup,” and then press [ENTER]. |
ENTER | The Speaker Setup menu appears. |
| |
| 3.Speaker Setup |
| |
| 1.Speaker Impedance |
| 2.Speaker Configuration |
ENTER | 3.Speaker Distance |
| 4.Level Calibration |
| 5.THX Audio Setup |
| 6.Equalizer Settings |
2
TAPE
or
VIDEO 3
Press and hold down the [TAPE] or [VIDEO 3] input selector but- ton (about 3 seconds) to change the setting.
Repeat this step to select MD, CDR, or HDD.
For the TAPE input selector, the setting changes in this order:
TAPE → MD → CDR → HDD →
For the VIDEO 3 input selector, the set- ting changes in this order:
VIDEO 3 → HDD → VIDEO 3 →
3 | Use the Up and Down [ | ]/[ | ] |
| buttons to select “Speaker |
| |
| Impedance,” and then press |
| |
| [ENTER]. |
|
|
4 | Use the Left and Right [ | ]/[ | ] |
| buttons to select: |
|
|
| 4 ohms: Select if the impedance of any | ||
ENTER | speaker is 4 ohms or more but | ||
| less than 6. |
|
|
6 ohms: Select if the impedances of all speakers are between 6 and 16 ohms.
Note:
HDD can be selected for the TAPE input selector or VIDEO 3 input selector, but not both at the same time.
5 | Press the [SETUP] button. |
| |
| Setup closes. |
Notes:
•This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.
46
