Common Functions—Continued
Using the Sleep Timer
With the sleep timer, you can set the AV receiver so that it turns off automatically after a specified period.
SLEEP | Press the remote controller’s | |||
| [SLEEP] button repeatedly to | |||
| select the required sleep time. | |||
| You can set the sleep time from 90 to 10 | |||
| minutes in 10 minute steps. | |||
| The SLEEP indicator appears on the | |||
| display when the sleep timer has been | |||
| set, as shown. The specified sleep time | |||
| appears on the display for about 5 sec- | |||
| onds, then the previous display reap- | |||
| pears. | |||
| SLEEP indicator | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
To cancel the sleep timer, press the [SLEEP] button repeatedly until the SLEEP indicator disappears.
Displaying Source Information
You can display various information about the current input source as follows.
Remote | Press the [DISPLAY] button |
controller | repeatedly to cycle through the |
| |
DISPLAY | available information. |
| |
AV receiver |
|
DISPLAY |
|
The following information can typically be displayed:
Input source & volume
Signal format* or sampling frequency
To check the remaining sleep time, press the [SLEEP] button. Note that if you press the [SLEEP] button while the sleep time is being displayed, you’ll shorten the sleep time by 10 minutes.
Using Headphones
For private listening, you can connect a pair of stereo headphones
STANDBY/ON
STANDBY
ZONE 2
POWER
ON 
OFF
PURE AUDIO
PHONES |
|
ZONE 2 | OFF |
Notes:
•Always turn down the volume before connecting your headphones.
Input source & listening mode
*If the input signal is analog, no format information is displayed. If the input signal is PCM, the sampling fre- quency is displayed. If the input signal is digital but not PCM, the signal format is displayed.
If the input signal is multichannel PCM, the sampling frequency and signal format will be displayed. Informa- tion is displayed for about 3 seconds, then the previous display reappears.
Interpreting Surround Channel Information
AB C
A:The number of front channels (front left, front right, and center).
B:The number of surround channels (surround left and surround right). If there’s surround back channel information, this number will be 3.
C:LFE channel for subwoofer (1 means yes).
•The speakers are turned off while the headphones plug is inserted in the PHONES jack. (The Zone 2 speakers are unaffected.)
•When you connect a pair of headphones, the listening mode is set to Stereo, unless it was set to Pure Audio, Mono, Stereo, or Direct, in which case it stays the same.
59
