Manual No. | LMD 1135 Laser Fixed Mount Scanner |
| Scanner Timeout (Trigger Enabled |
| Mode) |
Y1 | 1 second after triggering |
Y2 | 2 second after triggering |
Y3 | 3 second after triggering |
Y4 | 4 second after triggering |
Y5 | 5 seconds after triggering |
Y6 | 6 second after triggering |
Y7 | 7 seconds after triggering |
Y8 | 8 seconds after triggering |
Y9 | 9 seconds after triggering |
YL | Read time x 10 |
YM | Indefinitely after triggering |
|
|
XA | |
XB | |
XC | |
XD | |
|
|
AH | Multiple Read Reset Time – 50 msec |
AI | Multiple Read Reset Time – 100 msec |
AJ | Multiple Read Reset Time – 200 msec |
AK | Multiple Read Reset Time – 300 msec |
AL | Multiple Read Reset Time – 400 msec |
AM | Multiple Read Reset Time – 500 msec |
AN | Multiple Read Reset Time – 600 msec |
AG | Multiple Read Reset Time - Indefinite |
|
|
| Quiet Zone Options |
YN | No margin check |
YO | Margin check 1/7 nominal |
YP | Margin check 2/7 nominal |
YQ | Margin check 3/7 nominal |
YR | Margin check 4/7 nominal |
YS | Margin check 5/7 nominal |
YT | Margin check 6/7 nominal |
YU | Margin check normal |
|
|
| Redundant Decoding |
X0 | Read bar code once |
X1 | Read bar code twice before transmitting |
X2 | Read bar code three times before transmitting |
X3 | Read bar code four times before transmitting |
BS | Read bar code five times before transmitting |
BT | Read bar code six times before transmitting |
BU | Read bar code seven times before xmitting |
BV | Read bar code eight times before xmitting |
BW | Read bar code nine times before xmitting |
|
|
| Xmit Error (Trigger Enabled Mode only) |
TH | User defined error message for no label |
TI | User defined error message for no decode |
TG | Clear error messages for no label, no decode |
|
|
WD | Response to command - None |
WC | Response to command – OK=ACK, |
| ERROR=NAK |
|
|
WB | Buzzer Control to Command - Disable |
WA | Buzzer Control to Command - Enable |
|
|
| Good Read LED Operation |
T4 | Disable good read LED (GRL) |
T5 | GRL ON for 0.20 seconds after decode |
T6 | GRL ON for 0.40 seconds after decode |
T7 | GRL ON for 0.80 seconds after decode |
Page 23
