Manual No. | Series LGP Handheld CCD Scanner |
Part II Installation and SetUp
This section of the manual contains information on the physical installation of the scanner as well as certain programming options. There is a separate section for each type of interface. Check to see which type of interface your scanner has and turn to that section for information on installing the scanner
A.) Installation – Keyboard Wedge Interface
A "Y" connection cable is required for installation. The scanner is installed or "wedged" between the keyboard and the computer.. Your “Y” cable should have connectors for both a PS2 and AT type installation. The "Y" cable connects both the scanner and the keyboard to the computer.
The scanner must match the type of computer being used. The default setting is for an IBM AT type computer. If this type does not match the host computer, refer to the “Computer Type Selection” in the programming section that follows. If the connector does not match the host compute remove the short cable section, reverse it and insert it in the other connector
Page 5