Manual No. 25-ULGPMU01-01

Series LGP Handheld CCD Scanner

B.) Installation – RS232 Interface

The RS-232 scanner cable is terminated in with a DB9 female connector. An external power supply (+5V DC) may be necessary. There is a power supply jack on the RS-232 connector.

Installation is as follows:

1.Plug the scanner into an RS232 serial port (such as COM1) of the host PC. If external power is required, insert external power plug into the jack on the RS-232 connector.

2.Connect the power supply into an electrical outlet (110 V AC)

3.Turn on the power to the host computer. Make sure the communication parameters of the computer match those of the scanner. The default communications settings are: 9600 baud, 8 data bits, 1 stop bit, no parity, no handshaking

4.Be sure the PC is in a program (such as WordPad) that will accept input from the serial port.

Reset All Defaults – RS232

Our scanners are shipped with factory default settings that represent the settings most commonly used by our customers. In most applications, the scanner will work right out of the box without any need for additional programming. At any time you can return the scanner to the factory default settings by scanning the “Reset all Defaults” programming bar codes below. First scan the Start Program Menu bar code below, then scan the “Reset all Defaults” programming bar code, and then the End Program Menu bar.

ZZ

Start

[[ ￿

Program Menu

 

 

 

U2

RS232

V3 ￿

Reset all defaults

 

 

 

ZZ

End

[[ ￿

Program Menu

 

 

 

Page 9