Manual No. 25-ULGPMU01-01Series LGP Handheld CCD Scanner

Read Mode Settings

ZZ

Start/End

[[ ￿

 

Program

 

 

 

 

 

Menu

 

 

 

 

 

 

S0

Single

T1 ￿

 

read

 

 

 

 

%

S1

Multiple

T2 ￿

read

 

 

 

 

S2

Continuous

T3 ￿

 

read

 

 

 

 

 

XA

Add-on

YB ￿

 

wait mode

 

 

 

 

 

disabled

 

 

 

 

 

 

XB

Add-on

TC ￿

 

wait mode

 

 

 

 

 

0.25 sec.

 

 

 

 

 

 

XC

Add-on

YD ￿

%

0.50 sec.

 

wait mode

 

 

 

 

 

 

XD

Add-on

YE ￿

 

wait mode

 

 

 

 

 

0.70 sec.

 

 

 

 

 

 

Single Read - When a bar code has been decoded, the reader will be turned OFF. The reader must be triggered again to read another label. This option and "Disable trigger" cannot be programmed at the same time.

Multiple Read - When a bar code has been decoded, the reader will stay ON for a time as set by "read time settings" or indefinitely if the trigger switch has been disabled. The same label can only be decoded again after the label has not been detected for a number of scans.

Continuous Read - The reader will produce as much data as it can decode regardless whether it is the same or not. This mode is mainly used for demonstration and diagnosis.

Add-on Wait Mode - Used if UPC/EAN with add-on is enabled. The reader searches within the selected time for a valid add-on code. If a valid add-on code is found, the reader transmits the data immediately. If nothing is found behind the code, the scanner will transmit the data without add-on. If something is found behind the code, the reader ignored the code in case it is not a valid add-on.

Page 53