6.Adjust the sound with MASTER VOL- UME. See “Adjusting the Sound” on Page 12.
7.Set each connected microphone’s ON/OFF switch to ON. Sing directly into the microphone along with the music.
8.Use MIC VOL 1 and/or MIC VOL 2 to adjust the volume of each micro- phone.
9.Adjust ECHO and TONE CONTROL for the desired reverberation and pitch. See “Adjusting the Sound” on Page 12.
10.Adjust TAPE SPEED (if you are play- ing a tape). See “Adjusting the Sound” on Page 12.
11.To stop a tape, press STOP/EJECT
on the deck you are using.
Press STOP/EJECT 
again to open the cassette compartment door and remove the tape.
12.Set each microphone’s ON/OFF switch to OFF, then press POWER to turn off the system. The POWER indicator turns off.
WITH ANOTHER AUDIO SOURCE
If you connect another audio source, fol- low these steps to sing along with that audio source.
1.Set FUNCTION SELECTOR to AUX.
2.Press POWER to turn on the system. The POWER indicator lights.
3.Turn on the audio source.
4.Adjust the sound with the controls explained in “Adjusting the Sound” on Page 12.
5.Set each connected microphone’s ON/OFF switch to ON. Sing directly into the microphone along with the music.
6.Use MIC VOL 1 and/or MIC VOL 2 to adjust your voice’s volume.
7.When you finish, set each micro- phone’s ON/OFF switch to OFF, press POWER to turn off the system, then turn off the audio source.
THROUGH ANOTHER AUDIO COMPONENT
If you connected another audio compo- nent, follow the steps in “With Another Audio Source” so you can hear your voice and music through another com- ponent. Except in Step 3, turn on the au- dio component, and be sure to turn it off (Step 7) when you finish.
11
