9
English
Installation
Connecting the Projector to Desktop Computer
1.Make sure the projector and your computer are turned off.
2.Connect one end of the projector signal cable to the projector; connect the other end to the VGA connector on the computer and tighten the screws.
3.Connect one end of the power cord into the back of projector; connect the other end to an electrical outlet.
4.The adapter of remote receiver is connected to RS232C socket at the back of the computer.
Computer Output | RS232C |
VGA Cable |
|
Power Cord | Remote Receiver Cable |
|
vTo ensure the projection display works well with your computer, please configure the display mode of your graphic card to make it less than or equal to 1024 X 768 resolution. Make sure timimg of the display mode is compatible with the projection display. Refer to the“Compatibility Modes”section on page 28.
