Steady light 
No light 
Appendices
The projector stops responding to all controls
If possible, turn off the projector, then unplug the power cord and wait at least 60 seconds before reconnecting power.
Check that “Keypad Lock” is not activated by trying to control the projector with the remote control.
Lamp burns out or makes a popping sound
When the lamp reaches its end of life, it will burn out and may make a loud popping sound. If this happens, the projector will not turn on until the lamp module has been replaced. To replace the lamp, follow the procedures in the “Replacing the Lamp” section on pages
LED lighting message
Message | POWER/STAND- | |||
BY LED | ||||
|
|
| ||
| (Green/Amber) | (Red) | (Red) | |
Standby State | Amber |
|
| |
(Input power cord) |
|
| ||
|
|
| ||
Power on (Warming) | Flashing |
|
| |
Green |
|
| ||
|
|
| ||
Lamp lighting | Green |
|
| |
Power off (Cooling) | Flashing |
|
| |
Green |
|
| ||
|
|
| ||
Quick Resume(100 | Flashing |
|
| |
secs) | Green |
|
| |
Error (Over Temp.) | Flashing |
|
| |
Amber |
|
| ||
|
|
| ||
Error (Fan fail) | Flashing | Flashing |
| |
Amber |
| |||
|
|
| ||
Error (Lamp fail) | Flashing |
|
| |
Amber |
|
| ||
|
|
|
＊POWER/STANDBY LED be ON when OSD appears, be OFF when OSD disappears.
47English
