Connecting the Telephone Line | Oregon Scientific OS6976 guide

CONNECTING THE TELEPHONE LINE

1.Connect one end of the telephone line cord to the LINE jack on the bottom of the wall base unit.

2.Connect the other end of the telephone line cord to a telephone jack on the wall.

3.Raise the antenna on the base.

Connect to any other phone

CONNECTING THE AC (ELECTRICAL) POWER

1.Plug the wall base unit into an electrical outlet.

2.Make sure that its pins are inserted fully into the outlet and it is firmly installed. If not, choose another electrical outlet to plug into.

INSTALLING THE HANDSET BATTERY

NOTE: The handset battery and battery compartment cover are packaged together.

PRIOR TO USE

CONNECT BATTERY AND

INSTALL COVER

	PRESS DOWN	BATTERY
		RED
	FIRMLY
		WIRE

BLACK WIRE

CHARGE FOR 12 HOURS

1.Connect the battery cord into the jack inside the handset battery compartment and then insert the battery pack.

NOTE: It is important to maintain the polarity (black and red wires) to the jack inside the compartment as shown in the illustration. For this purpose and your convience the battery plug and jack are keyed so they will only mate in one direction.

2.Close the battery compartment by pushing the cover up until it snaps into place.

EN

6

os6976-en1.p65

9

5/6/2005, 10:32 AM

Image 9

Oregon Scientific OS6976 Connecting the Telephone Line, Connecting the AC Electrical Power, Installing the Handset Battery

Contents

900MHz Cordless Phone with Kitch Companion 900MHz Cordless Phone with Kitchen Companion Model OS6976 Table of Contents Answering System Memory Full Important Safety Instructions Save These Instruction Digital Security System Introduction Before YOU Begin Parts ChecklistSaftey Precuations Spacemaker Unit Installation Guidelines Installing the PhoneTelephone Jack Requirements Connecting the Telephone Line Connecting the AC Electrical PowerInstalling the Handset Battery Charge Unit Charging the Handset BatteryUnder Cabinet Mounting Tools Required Before Mounting Mounting Hardware Packed with Your Unit Mounting Procedure If your cabinet does not have an overhangIf your cabinet has an overhang If your cabinet does not have an overhang, go to Step Cord hooks Charge Unit Layout Handset and Wall Base Unit Layout Charge Unit Setup System Setup Ringer SetupLanguage Local Area Code TONE/PULSE Dialing Display ContrastAnswering System ON/OFF Setting the Rings to Answer Setting the Security Code for Remote AccessCharge Unit Handset Unit Default Settings SET Ringer Registration Handset Operation Making a Call Receiving a CallLine in USE WAY Conferencing Flash USE Indicator LightAuto Standby Channel Button Speakerphone Operation Call Transer Charge Indicator Light Speaker Indicator LightSpeakerphone Volume Display Backlight Answering System Operation Message Playback Remote AccessAnswering System Memory Full Erasing Messages Call Waiting Caller ID Caller ID CID Receiving and Storing Calls Reviewing CID RecordsTransferring CID Records to Memory Deleting ALL CID Records Deleting the CID Record Showing in the DisplayDialing a CID Number Changing the CID Number Format Radio Operation Storing a Name and Number in Memory MemoryChanging a Stored Number Storing a Redial Number Dialing a Stored Number Inserting a Pause in the Dialing SequenceReviewing and Deleting Stored Numbers Setting the Timer Programmable TimerChain Dialing from Memory At the handset Stopping the Timer Starting the TimerPausing the Timer Using the Timer with Other Modes Display Messages Charging the Battery Handset Sound Signals Connecting AN Optional Headset to the HandsetHeadset and Belt Clip Operation Connecting the Belt Clip Troubleshooting TipsCaller ID Telephone Os6976-en1.p65 2005, 1033 AM FCC Statement About Oregon Scientific Consumer Informations This equipment is hearing aid compatible Declare that the product Declaration of Conformity