Oregon Scientific RMR612HGA Turn Atomic Clock ON/OFF, SET Clock, Switch Clock Display

EN

CLOCK

This product shows the current time, time zone, and day of week in English, Spanish, or French. The time is automatically updated by the US Atomic Clock in Boulder, Colorado unless you disable this feature. Signals are collected by the main unit when it is within 1500 km (932 miles) of a signal.

Initial reception takes 2 - 10 minutes, and is initiated when you first setup the unit, and whenever you press RESET. Once complete, the reception icon will stop blinking. The icon is shown in the Clock Area.

To force a manual search for Atomic Clock signals, press and hold UP for 2 seconds. If no signal is found, check the batteries.

TURN ATOMIC CLOCK ON/OFF

Perform this step if you cannot receive Atomic Clock signals. Press and hold ZONE (located in the battery compartment) for 2 seconds. Then, manually set the clock following the “Set Clock” instructions (below).

The signal icon indicates that the Atomic Clock

feature is ON. No icon means that it is OFF.

8

SET CLOCK

You only need to do this if you have disabled the Atomic Clock feature (for example, if you are too far from or cannot receive a signal).

1.Open the battery compartment.

2.Press ZONE repeatedly to display the desired Time Zone: (P) Pacific, (M) Mountain, (C) Central, or

(E) Eastern.

3.Close the battery compartment.

4.Press and hold MODE for 2 seconds. The Clock Area will blink.

5.Select the hour, minute, year, month, day, and language. Press UP or DOWN to change the setting. Press MODE to confirm.

NOTE The language options are (E) English,

(F) French, and (S) Spanish.

SWITCH CLOCK DISPLAY

Press MODE to toggle between Clock with Seconds and Clock with Weekday display.

RMR612HGA lab test R2 8 1/17/04, 4:58 PM