Operation
To program a receive channel.
1.Press and hold the 60Rx button for 2 seconds, the display will show channel 41. to select a different channel use the Channel control.
2.Press the PRI button, the 450 in the frequency display will start blinking, use the Channel control to select the desired MHz.
3.Press the PRI button, the 000 in the frequency display will start blinking, use the Channel control to select the desired KHz.
4.Press MEM, the frequency is stored to that channel.
Factory Reset
Should it be necessary you can return all the UHF050 settings to the factory defaults to do this.
1.Switch the unit OFF.
2.Press and hold the CALL button.
3.While still holding the Call button, turn the power switch to ON, this will reset the factory defaults.
18
