Over And Back PAP2 manual

Phone Adapter with 2 Ports for Voice-over-IP

5.For each port range you must specify, enter a different name in the Application field. Then enter the number or range of external port(s) used by the Phone Adapter.

6.Select the protocol you will be using, UDP.

7.Enter the IP address of the Phone Adapter. For example, if the Phone Adapter’s IP address is 192.168.1.100, you would enter 100 in the field provided.

8.Repeat steps 5-7 until you have entered all four port ranges for the Phone Adapter.

Application	Start and End	Protocol	IP Address	Enable

Internet phone 1	5060 to 5061	UDP	(IP address of	X
			Phone Adapter)

Internet phone 2	53 to 53	UDP	(IP address of	X
			Phone Adapter)

Internet phone 3	69 to 69	UDP	(IP address of	X
			Phone Adapter)

Internet phone 4	10000 to 20000	UDP	(IP address of	X
			Phone Adapter)

9.Check the Enable option for the port services you want to use.

10.When you have completed the configuration, click the Save Settings button.

Appendix A: Troubleshooting

19

Common Problems and Solutions

Image 25

Over And Back PAP2 manual Application Start and End Protocol IP Address Enable

Contents

Phone Adapter Page Copyright and Trademarks How to Use this Guide Phone Adapter with 2 Ports for Voice-over-IP Table of Contents Front Panel Back Panel Welcome IntroductionWhat’s in this Guide? Introduction Back Panel Ports Getting to Know the Phone Adapter Phone Adapter’s LEDs are located on the front panel Front PanelIncoming call has been detected An incoming call has been detected Instructions for Connecting the Phone Adapter Connecting the Phone AdapterOverview Internet Connect the Telephone Cable Follow the instructions provided by Vonage Stand Option Placement OptionsRemove the plate from the Phone Adapter’s bottom panel Phone Adapter’s Interactive Voice Response Menu Measurement between Wall-Mount Slots Wall-Mount Option Accessing the Interactive Voice Response Menu Using the Phone Adapter’s Interactive Voice Response MenuUsing the Interactive Voice Response Menu Interactive Voice Response Menu Use this command to enter Response MenuNot press any other keys until you Key or hang up to exit 101 Enter 1 to enable Has been enabled or disabled. IfEnter 0 to disable Check Dhcp 100 Static IP address When entering a Decimal point Address usingSubnet Mask Mask using Network mask When entering a Decimal point Static gateway IP address When entering a Decimal point Address Address usingPhone Adapter Manual Reboot 732668 131 Enter the IP Configuring the Settings for Your Internet Phone Service Common Problems and Solutions Appendix a Troubleshooting Appendix a Troubleshooting Internet phone 5060 to Application Start and End Protocol IP Address EnableIP address Phone Adapter Internet phone 53 to IP address Phone Adapter Internet phone 69 to Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Ethernet LED does not light up Frequently Asked Questions Can I make calls while I’m browsing the Internet? Shared Resources Appendix B Windows HelpNetwork Neighborhood/My Network Places Appendix B Windows Help Appendix C Glossary Appendix C Glossary Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Appendix D Specifications Storage Humidity ~90% Non-Condensing Dimensions 98 x 3.98 x H x DMm x 101 mm x 15 mm Limited Warranty Appendix E Warranty Information Appendix E Warranty Information FCC Statement Appendix F Regulatory Information Appendix F Regulatory Information Linksys VonageToll-free from US