Getting to Know the Phone Adapter | Over And Back PAP2 guide

Phone Adapter with 2 Ports for Voice-over-IP

Chapter 2: Getting to Know the Phone Adapter

Back Panel Ports

The Phone Adapter’s ports are located on the back panel.

	Figure 2-1: Back Panel
PHONE 1 Port	For your primary Vonage Internet phone line, the PHONE 1 port allows you to connect your
	telephone to the Phone Adapter using an RJ-11 telephone cable (not included).
PHONE 2 Port	If you add a second Vonage line, then use the PHONE 2 port. It allows you to connect a
	second telephone (or fax machine) to the Phone Adapter using an RJ-11 telephone cable
	(not included).
ETHERNET Port	The ETHERNET port allows you to connect the Phone Adapter to your router or gateway
	using a Category 5 (or better) Ethernet network cable.

NOTE: These Phone ports do not carry any voltage.

POWER Port	The POWER port is where you will connect the included power adapter.
Chapter 2: Getting to Know the Phone Adapter		3

Back Panel Ports

Image 9

Over And Back PAP2 manual Getting to Know the Phone Adapter, Back Panel Ports

Contents

Phone Adapter Page Copyright and Trademarks How to Use this Guide Phone Adapter with 2 Ports for Voice-over-IP Table of Contents Front Panel Back Panel Introduction WelcomeWhat’s in this Guide? Introduction Back Panel Ports Getting to Know the Phone Adapter Phone Adapter’s LEDs are located on the front panel Front PanelIncoming call has been detected An incoming call has been detected Instructions for Connecting the Phone Adapter Connecting the Phone AdapterOverview Internet Connect the Telephone Cable Follow the instructions provided by Vonage Stand Option Placement OptionsRemove the plate from the Phone Adapter’s bottom panel Phone Adapter’s Interactive Voice Response Menu Measurement between Wall-Mount Slots Wall-Mount Option Using the Phone Adapter’s Interactive Voice Response Menu Accessing the Interactive Voice Response MenuUsing the Interactive Voice Response Menu Interactive Voice Response Menu Use this command to enter Response MenuNot press any other keys until you Key or hang up to exit 101 Enter 1 to enable Has been enabled or disabled. IfEnter 0 to disable Check Dhcp 100 Static IP address When entering a Decimal point Address usingSubnet Mask Mask using Network mask When entering a Decimal point Static gateway IP address When entering a Decimal point Address Address usingPhone Adapter Manual Reboot 732668 131 Enter the IP Configuring the Settings for Your Internet Phone Service Common Problems and Solutions Appendix a Troubleshooting Appendix a Troubleshooting Internet phone 5060 to Application Start and End Protocol IP Address EnableIP address Phone Adapter Internet phone 53 to IP address Phone Adapter Internet phone 69 to Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Ethernet LED does not light up Frequently Asked Questions Can I make calls while I’m browsing the Internet? Appendix B Windows Help Shared ResourcesNetwork Neighborhood/My Network Places Appendix B Windows Help Appendix C Glossary Appendix C Glossary Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Appendix D Specifications Dimensions 98 x 3.98 x H x D Storage Humidity ~90% Non-CondensingMm x 101 mm x 15 mm Limited Warranty Appendix E Warranty Information Appendix E Warranty Information FCC Statement Appendix F Regulatory Information Appendix F Regulatory Information Vonage LinksysToll-free from US