Check Dhcp 100, Use a static IP address | Over And Back PAP2

Phone Adapter with 2 Ports for Voice-over-IP

Interactive Voice Response Menu

Action	Command	Choices	Description
	(press these
	keys on the
	telephone)

Check DHCP	100		Use this command to find out if DHCP
			has been enabled or disabled. If
			enabled, the Phone Adapter will be
			automatically assigned an IP address
			by your network router or gateway. If
			disabled, then the Phone Adapter will
			use a static IP address.

Enable/Disable DHCP	101	Enter 1 to enable	Enable or disable the Phone Adapter’s
		Enter 0 to disable	DHCP feature. If your network router
			or gateway assigns IP addresses, then
			enter 1. Otherwise, enter 0.

Check IP Address	110		You will hear the current IP address of
			the Phone Adapter.

Chapter 4: Using the Phone Adapter’s Interactive Voice Response Menu

11

Using the Interactive Voice Response Menu

Image 17

Over And Back PAP2 manual Check Dhcp 100, Has been enabled or disabled. If, Use a static IP address, Enter 1 to enable

Contents

Phone Adapter Page Copyright and Trademarks How to Use this Guide Phone Adapter with 2 Ports for Voice-over-IP Table of Contents Front Panel Back Panel What’s in this Guide? IntroductionWelcome Introduction Back Panel Ports Getting to Know the Phone Adapter Phone Adapter’s LEDs are located on the front panel Front PanelIncoming call has been detected An incoming call has been detected Instructions for Connecting the Phone Adapter Connecting the Phone AdapterOverview Internet Connect the Telephone Cable Follow the instructions provided by Vonage Stand Option Placement OptionsRemove the plate from the Phone Adapter’s bottom panel Phone Adapter’s Interactive Voice Response Menu Measurement between Wall-Mount Slots Wall-Mount Option Using the Interactive Voice Response Menu Using the Phone Adapter’s Interactive Voice Response MenuAccessing the Interactive Voice Response Menu Interactive Voice Response Menu Use this command to enter Response MenuNot press any other keys until you Key or hang up to exit 101 Enter 1 to enable Has been enabled or disabled. IfEnter 0 to disable Check Dhcp 100 Static IP address When entering a Decimal point Address usingSubnet Mask Mask using Network mask When entering a Decimal point Static gateway IP address When entering a Decimal point Address Address usingPhone Adapter Manual Reboot 732668 131 Enter the IP Configuring the Settings for Your Internet Phone Service Common Problems and Solutions Appendix a Troubleshooting Appendix a Troubleshooting Internet phone 5060 to Application Start and End Protocol IP Address EnableIP address Phone Adapter Internet phone 53 to IP address Phone Adapter Internet phone 69 to Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Ethernet LED does not light up Frequently Asked Questions Can I make calls while I’m browsing the Internet? Network Neighborhood/My Network Places Appendix B Windows HelpShared Resources Appendix B Windows Help Appendix C Glossary Appendix C Glossary Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Appendix D Specifications Mm x 101 mm x 15 mm Dimensions 98 x 3.98 x H x DStorage Humidity ~90% Non-Condensing Limited Warranty Appendix E Warranty Information Appendix E Warranty Information FCC Statement Appendix F Regulatory Information Appendix F Regulatory Information Toll-free from US VonageLinksys