Cisco Systems Network Switch Cabling instruction

7. Set the host name of the switch stack, as follows:

At this prompt...	Enter...	Notes

Switch(config)#	hostname sw01	Use your site-specific name instead
		of sw01 used as an example; each
		switch should have a unique name.

8.	Set the switch stack’s enable password, as follows:

At this prompt...	Enter...	Notes

sw01(config)#	enable secret system	Use your site-specific password
		instead of the system password used
		as an example.

9.	Turn off the VLAN trunking protocol (VTP), as follows:

At this prompt...	Enter...			Notes

sw01(config)#	vtp mode transparent			Displays the following output:
	sw01(config)#
	Setting device to VTP TRANSPARENT mode.
10.	Enable the portfast bpduguard feature, as follows:

At this prompt...	Enter...		Notes

sw01(config)#	spanning-tree portfast bpduguard default		Enabling this feature protects
			against cabling errors. If a spanning
			tree packet does arrive on a port
			that has this feature enabled, the
			port is disabled.

CASSATT ACTIVE RESPONSE CONTROL NODE AND NETWORK SWITCH CABLING EXAMPLE

26

Image 11

Cisco Systems Network Switch Cabling manual Set the host name of the switch stack, as follows

Contents

Port numbering Control Node and Network Switch Cabling Example Switch Panel and Control Node Cabling Shows how each port is used on the switch and control node Up application nodes Racking and cabling guidelines Then Connecting the switch to a terminal server Configuring the switches Delete the Vlan database, as follows Restoring the factory default settings Renumber the switch, as follows Enter the configuration mode, as follows Halt and perform a cold restart, as follows Setting switch optionsExit the configuration mode, as follows Turn the messages off, as follows Enter the configuration mode, as followsTurn off all interfaces on the first switch, as follows Enter the privileged mode, as follows Turn off the Vlan trunking protocol VTP, as follows Set the host name of the switch stack, as followsSet the switch stack’s enable password, as follows Should be sent over it Set the interface connection to the router, as follows Setting the portfast option means Message as required by Disable Igmp snooping, as followsTurn off the Http server, as follows Set the message of the day, as follows Turn logging to the console back on, as follows Exit the configuration mode, as followsVerify the switch configuration, as follows Turn all the interfaces back on, as followsPage XXX Displays the following output