Cisco Systems Network Switch Cabling manual Enter the privileged mode, as follows

2. Enter the privileged mode, as follows:

At this prompt...		Enter...			Notes
Switch>		enable
	3. Enter the configuration mode, as follows:
At this prompt...		Enter...			Notes
Switch#		configure terminal			Displays the following output:
	Enter configuration commands, one per line. End with CNTL/Z.
	4. Turn the messages off, as follows:
At this prompt...		Enter...			Notes
Switch(config)#		no logging console			Some of the switch configuration
					commands can produce many
					messages that are logged to the
					console, which is often
					inconvenient.
	5. Turn off all interfaces on the first switch, as follows:
At this prompt...		Enter...			Notes
Switch(config)#		interface range GigabitEthernet 1/0/1 – 24		This step is done to prevent
					network loops from forming
					because the configuration is only
					partially enabled at this time.
Switch(config-if-		shutdown
range)#
Switch(config-if-		exit
range)#
	6. Turn off all the interfaces on the second switch, as follows:
At this prompt...		Enter...			Notes
Switch(config)#		interface range GigabitEthernet 2/0/1 – 24	This is done for the same reason as
					stated in the previous step.
Switch(config-if-		shutdown
range)#
Switch(config-if-		exit
range)#

CASSATT ACTIVE RESPONSE CONTROL NODE AND NETWORK SWITCH CABLING EXAMPLE 25