Cisco Systems Network Switch Cabling Disable Igmp snooping, as follows, Message as required by

%Portfast will be configured in 23 interfaces due to the range command but will only have effect when the interfaces are in a non-trunking mode

At this prompt...		Enter...		Notes
sw01(config-if-range)#		switchport mode access
sw01(config-if-range)#		exit
	14. Disable IGMP snooping, as follows:
At this prompt...		Enter...	Notes
sw01(config)#		no ip igmp snooping	IGMP snooping is disabled to resolve communication issues
			with the bonded Ethernet interfaces, IGMP snooping, and
			multicast. By default, IGMP snooping is globally available on the
			switch. With IGMP snooping, multicast packets are forwarded
			only to the ports that have joined that multicast group. When
			IGMP snooping is disabled, multicast packets are forwarded to
			all ports on the switch.
			If disabling IGMP snooping impacts network performance, and
			if non-Cassatt Active Response applications running on the
			Cassatt Active Response system do not use the multicast
			functionality, disabling IGMP snooping can be done on the
			control nodes only. In this case, do not disable IGMP snooping
			on the switch; instead, refer to the Catalyst 3750 Switch Software
			Configuration Guide to configure the four interfaces on the
			control nodes to statically join the multicast group.
	15. Turn off the HTTP server, as follows:
At this prompt...		Enter...		Notes
sw01(config)#		no ip http server		The HTTP server is not used and
				is turned off as a security
				precaution.
	16. Set the message of the day, as follows:
At this prompt...		Enter...		Notes
sw01(config)#		banner motd #		Displays the following output; set
				the message as required by
				your site policy:

Enter TEXT message. End with the character '#'.

*************************************

insert message here

*************************************

#

CASSATT ACTIVE RESPONSE CONTROL NODE AND NETWORK SWITCH CABLING EXAMPLE 29