Changing Switch Number 3 to Switch Number 2 New Switch Number will be effective after next reboot
6. Exit the configuration mode, as follows:
At this prompt... | Enter... |
| Notes |
|
|
|
|
|
|
sw01# | exit |
|
|
|
7. Halt and perform a cold restart, as follows: |
|
|
| |
|
|
|
| |
At this prompt... | Enter... | Notes |
| |
|
|
|
|
|
sw01> | reload |
|
|
|
System configuration has been modified. | no |
|
|
|
Save? [yes/no]: |
|
|
|
|
Proceed with reload? [confirm] | y | Displays the following output: |
| |
00:08:23:
Base ethernet MAC Address: 00:11:bb:7e:94:80 Xmodem file system is available.
The
flashfs[0]: 79 files, 4 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 15998976
flashfs[0]: Bytes used: 6457856
flashfs[0]: Bytes available: 9541120
flashfs[0]: flashfs fsck took 8 seconds.
...done Initializing Flash.
Boot Sector Filesystem (bs) installed, fsid: 3 done.
...
Press RETURN to get started!
Proceed to step 1 in Setting switch options on page 24 to continue the switch configuration procedure.
Setting switch options
This procedure provides the minimal configuration required to support the reference system. Configure the first switch stack as follows:
1. Select the Enter key to get started. Skip the initial configuration, as follows:
At this prompt... | Enter... | Notes |
|
|
|
no |
| |
would you like to enter the initial configuration |
|
|
dialog? [yes/no]: |
|
|
CASSATT ACTIVE RESPONSE CONTROL NODE AND NETWORK SWITCH CABLING EXAMPLE | 24 |
