•Corner fittings should be attached to the top bar.
•Swing hooks should be in place on the top bar.
•Hardware for the legs should be in place in the corner fitting prongs.
•Hardware for the support bars should be in place on the legs.
Step Illustration | Instructions |
1 | Remove the hardware from the prong of a |
| corner fitting in order to insert one of the |
| legs. |
2 | Align the two sets of holes and replace the |
| hardware through the corner fitting prong |
| and leg to secure the leg. Do not over |
| tighten the screws. After all parts are |
| assembled you will need to tighten again. |
|
|
3 | Repeat the process for the other leg on the |
| corner fitting. |
| Follow the next step before proceeding with |
| the legs on the opposite side. |
|
|
4 | One of the top bar sections should have pre- |
| assembled hardware. Remove the hardware |
| and join the two top bar sections together. |
| Then attach the two center legs with the |
| bent ends by aligning the holes with those |
| of the joined top bar and |
| hardware. It is recommended that a |
| minimum of 2 adults complete this step. |
| NOTE: It may be helpful to prop up the |
| side of the top bar without the legs about |
| one foot off the ground in order to align the |
| top bar sections and center legs properly. |
| Once the center legs are attached, assemble |
| the remaining outside legs and then stand |
| up the swing set frame. |
5 | Remove the hardware from the middle |
| section of a leg. Match up the holes of the |
| |
| hardware through both. Repeat the process |
| for the opposite side and center legs. It |
| may be necessary to pull both legs towards |
| each other in order for the holes to align |
| properly. |
Hardware Reference Part Ref. #: PSHW10
Part Ref. #: PSHW10
Part Ref. #: PSHW10
Part Ref. #: PSHW10
Part Ref. #: PSHW10
Part Ref. #: PSHW12
6 | ©2006 Pacific Cycle, Inc. |