Pacific Cycle 22-PS245 owner manual Part Ref. #: PSHW24 Part Ref. #: PSHW24

2

3

4

5

6

7

Insert the rail/ladder legs through the holes in the top of the slide. Align the ladder holes with the slide holes.

Insert the screws through the holes in the back of the slide and secure them to the hand rails with the screws and locking nuts provided.

Locate the slide front leg and insert it into the front outside hand rail tube, on the underside of the slide. Place a screw in that hole and secure it with the lock nut.

NOTE: For stability, this leg should be placed on the outside of the slide, opposite the swing set frame.

Insert the screw into the remaining hole on the slide and secure the hand rail to the slide with the lock nut.

Slide the two ladder steps onto the legs of the slide. Align the holes and secure the steps with the screws and locking nuts. The screw head should be facing the outside.

NOTE: Once assembled and the slide is standing upright, the steps should be flat and parallel with the ground. If they are at an angle, they will need to be removed, turned around, and reassembled.

To attach the slide to the frame, locate the two link bars, remove the hardware, and re-attach to the side support bar with the holes.

Part Ref. #: PSHW24

Part Ref. #: PSHW24

Part Ref. #: PSHW24

Part Ref. #: PSHW5

Part Ref. # PSHW17

TIP: In order to keep the slide legs from sinking into the ground, place a flat rock or a brick under the legs. You should dig out a place for the brick so the slide remains even.

10 ©2006 Pacific Cycle, Inc.