V - Brake
1.If fitted with
body into the center spring hole in the frame mounting boss, and then secure the brake body to the frame with the link fixing bolt.
2.While holding the shoe against the rim, adjust the amount of shoe protrusion by interchanging the position of the B washers (i.e. 6 mm and 3 mm) so that dimension A is kept at 39 mm or more.
39 mm or more
3. While holding the shoe against the | 5. Adjust the balance with the spring |
rim, tighten the shoe fixing nut. | tension adjustment screws. |
5 mm Allen key
| Washer | |
Spring | Link | |
fixing | ||
hole | ||
bolt | ||
|
A
3 mm washer B 6 mm washer B
Shoe fixing nut
Washer A | Washer |
| shoe fixing nut |
1mm | 5 mm Allen key |
|
4.Pass the inner cable through the inner cable lead. Set the cable with a clearance of 1mm between each brake pad and the rim, tighten the cable fixing bolt.
5 mm Allen key
1 mm | 1 mm |
Spring tension | Spring tension |
adjustment screw | adjustment screw |
6.Depress the brake lever about 10 times as far as the grip to check that everything is operating correctly and that the shoe clearance is correct before using the brakes.
Depress about 10 times
17
Stopper pin |
Shoe fixing link
Washer A
1mm 1mm
18
