SAFETY CHECKLIST
Before every ride, it is important to carry out the following safety checks:
1. Brakes
-Ensure front and rear brakes work properly.
-Ensure brake shoe pads are not over worn and are correctly positioned in relation to the rims.
-Ensure brake control cables are lubricated, correctly adjusted and display no obvious wear.
-Ensure brake control levers are lubricated and tightly secured to the handlebar.
2. Wheels and Tires
-Ensure tires are inflated to within the recommended limit as displayed on the tire sidewall.
-Ensure tires have tread and have no bulges or excessive wear.
-Ensure rims run true and have no obvious wobbles or kinks.
-Ensure all wheel spokes are tight and not broken.
-Check that axle nuts are tight. If your scooter is fitted with quick release axles, make sure locking levers are correctly tensioned and in the closed position.
3. Steering
- Ensure handlebar and stem are correctly adjusted and tightened, and allow proper steering.
-Ensure that the handlebars are set correctly in relation to the forks and the direction of travel.
-Check that the headset locking mechanism is properly adjusted and tightened.
-If the scooter is fitted with handlebar end extensions, ensure they are properly positioned and tightened.
4. Bearings
- Ensure all bearings are lubricated, run freely and display no excess movement, grinding or rattling. - Check headset, wheel bearings, pedal bearings and bottom bracket bearings.
05
Helmets
It is strongly advised that a properly fitting, ANSI or SNELL approved, bicycle safety helmet be worn at all times when riding your scooter.
The correct helmet should: - be comfortable
- be lightweight
-have good ventilation
-fit correctly
- cover forehead
Always wear a properly fitted helmet which covers the forehead when riding a scooter. Many states require specific safety devices. It is your responsibility to familiarize yourself with the laws of the state where you ride and to comply with all applicable laws, including properly equipping yourself and your scooter as the law requires. Reflectors are important safety devices which are designed as an integral part of your scooter.
FRONT REFLECTOR ASSEMBLY
1.Locate front reflector brackets and screws in the parts box.
2.Assemble clear front reflector to lower fork crown using
(2)screws provided. Face reflector forward and tighten
(2)screws securely. Reflector bracket should be +/- 3 degrees from vertical (90 degrees).
06
