Final Check
- If you encounter any problems, refer to the appropriate section and make any necessary adjustments.
- Check the tire pressure and inflate each tube to the recommended |
psi as stated on the sidewall of the tire. |
- Check that the kickstand operates smoothly and the |
kickstand bolt is secured tightly. |
- Finally, examine the scooter. Make sure all accessories are |
attached and all quick releases, nuts and bolts have been |
tightened securely. |
SCOOTER
Foreword: Assembling a scooter is an important responsibility. Proper assembly not only gives the rider more enjoyment of the scooter; it also offers an important measure of safety.
Getting Started
Open the carton from the top and remove the scooter. Remove the straps and protective wrapping from the scooter. Inspect the scooter and all accessories and parts for possible shortages. It is recommended that the threads and all moving parts in the parts package be lubricated prior to installation. Do not discard packing materials until assembly is complete to insure that no required parts are accidentally discarded. Assemble your scooter following the steps that pertain to your model.
Note: Your scooter may be equipped with different style components than the ones illustrated.
- Correct maintenance of your scooter will ensure many years |
of happy riding. Service your scooter regularly by referring |
to the relevant sections of this manual, OR take it to a |
professional bicycle shop.
Remember: Always wear a helmet and obey all traffic laws.
23
Never inflate a tire beyond the maximum pressure marked on the tire’s sidewall. Exceeding the recommended pressure may blow the tire off the rim, which could cause damage to the scooter and injury to the rider and bystanders.
Tighten both rear wheel axle nuts or the quick release mechanism securely. Failure to do this may cause the rear wheel to dislodge from the frame dropouts resulting in serious damage or injury.
Stem Cap Binder Bolts
Stem
Bolt 
| Minimum |
| Insertion Mark |
| Stem Wedge |
| Head |
| Tube |
Four Bolt | Six Bolt |
Face | Face |
Plate | Plate |
four bolt six bolt face plate
Handlebars
Remove the protective cap from the stem wedge and loosen the stem bolt using the 6mm Allen key. Some models may use a 13mm hexagonal bolt instead of an Allen key bolt. Place the handlebar stem into the head tube, observing the minimum insertion mark on the handlebar stem and ensuring that all cables are free of tangles. Check that the fork and the handlebar are facing forward, and that they are properly aligned with the front wheel. Tighten the stem bolt. Rotate the handlebar to the desired position. Tighten stem cap bolt 1 (see picture) two turns, tighten stem cap bolt 2 two turns and so on. Repeat until handle bar is secure to the stem. See picture for a 4 or
The handlebar must be inserted so that the minimum insertion mark cannot be seen. WARNING: Over tightening the stem bolt or headset assembly may cause damage to the scooter and/ or injury to the rider.
24
