Chapter 2

System Utilities

CMOS Setup Utility

CMOS Setup Utility is a hardware configuration program built into the system ROM. Since most systems are already properly configured and optimized, there is normally no need to run this utility.

You will need to run this utility under the following conditions:

When changing the system configuration including:

Setting the system time and date

Configuring the system drives and peripherals

Specifying the boot device sequence

Configuring the power management modes

Setting up system passwords or making other changes to the security setup

When trying to resolve IRQ conflicts

When a configuration error is detected by the system and you are prompted ("Run Setup" message) to make changes to the BIOS settings.

The Setup Utility loads the configuration values in a battery-backed nonvolatile memory called CMOS RAM. This memory area is not part of the system RAM, which allows configuration data to be retained when power is turned off. The values take effect when the system is booted. POST uses these values to configure the hardware. If the values and the actual hardware do not agree, POST generates an error message. You must run this utility to change the hardware settings from the default or current configuration.

IMPORTANT If you repeatedly receive “Run Setup” messages, the RTC battery located on the mainboard (BT1) may be defective. In this case, the system cannot retain configuration values in CMOS. Replace the RTC battery with a new one.

NOTE For ease of reading, CMOS Setup Utility will be simply referred to as “Setup” or “Setup Utility” in this Service Guide.

Packard Bell oneTwo M3600 AIO Computer Service Guide

9

Page 17
Image 17
Packard Bell M3600 manual System Utilities, Cmos Setup Utility