Packard Bell W7 manual LCD display cable, Wireless antenna

Models: W7

1 18

Page 13

15.Remove the screws (3x D, 1xA) from the left LCD bracket. The same goes for the right bracket.

16.Take away the top, left and right bracket from the LCD display panel.

17.Remove the screws (2xD) holding the wireless antenna and take away the antenna.

Image 13

Contents

Packard Bell EasyNote W7 Series Dragon SN Disassembly Manual Table of Contents Reassembly Instructions Disassembly InstructionsOverview Required ToolsHazardous Voltage Power Supply UnitAvoid Electrostatic Discharge WARNUNGAVVERTENZA WAARSCHUWINGRemoving the Hard Disk Drive Battery and AC AdapterBottom Panel CPU, VGA Module and Heat Sink Top Cover 9. Remove the screw 1xD and remove the lid switch unit 8. Disconnect the lid switch connectorFig. 11 Disconnecting touchpad flat cable Fig. 13 Lid switch and hingesDisassembling the LCD Panel Assembly Removing the LCD Panel Assembly11. Remove the lower supporting bracket 10. Disconnect the inverter backlight connector12. Take away the LCD display panel and inverter board 13. Disconnect the LCD cable from the inverter boardFig. 18 LCD display cable Fig. 19 Wireless antennaTo remove the optical disk drive, follow the steps below Optical Disk Drive2. Remove the screws 2xK from the side ODD bracket and remove it 3. Remove the screws 2xK from the rear ODD bracket and remove itDisassemble the bottom base assembly as follows Bottom Base AssemblyFig. 23 The bottom base assembly 1. First remove the screws 4XA from the top coverMain Board Assembly Fig. 27 The touch pad connector 12. Push out the touchpad assembly8. Take away the main board 9. Partially remove the foil over the touchpadEasyNote W7 Dragon SN Disassembly Manual