Manuals
/
Packard Bell
/
Computer Equipment
/
Laptop
Packard Bell
W7 Optical Disk Drive, To remove the optical disk drive, follow the steps below
Models:
W7
1
14
18
18
Download
18 pages
13.31 Kb
11
12
13
14
15
16
17
18
<
>
Disconnecting touchpad flat cable
Packard Bell EasyNote W7 Series Dragon SN Disassembly Manual
Battery and AC Adapter
Power Supply Unit
Disconnect the inverter backlight connector
Page 14
Image 14
12
Optical Disk Drive
To remove the optical disk drive, follow the steps below:
1. Remove the screws (2xB) and push the optical disk drive out of its bay.
Fig. 20
The screws of the optical disk drive.
2.
Remove the screws (2xK) from the side ODD bracket and remove it.
3.
Remove the screws (2xK) from the rear ODD bracket and remove it.
Fig. 21
The screws of the optical disk drive brackets.
Page 13
Page 15
Page 14
Image 14
Page 13
Page 15
Contents
Packard Bell EasyNote W7 Series Dragon SN Disassembly Manual
Table of Contents
Overview
Disassembly Instructions
Reassembly Instructions
Required Tools
Avoid Electrostatic Discharge
Power Supply Unit
Hazardous Voltage
WARNUNG
WAARSCHUWING
AVVERTENZA
Battery and AC Adapter
Removing the Hard Disk Drive
Bottom Panel
CPU, VGA Module and Heat Sink
Top Cover
Fig. 11 Disconnecting touchpad flat cable
8. Disconnect the lid switch connector
9. Remove the screw 1xD and remove the lid switch unit
Fig. 13 Lid switch and hinges
Removing the LCD Panel Assembly
Disassembling the LCD Panel Assembly
12. Take away the LCD display panel and inverter board
10. Disconnect the inverter backlight connector
11. Remove the lower supporting bracket
13. Disconnect the LCD cable from the inverter board
Fig. 19 Wireless antenna
Fig. 18 LCD display cable
2. Remove the screws 2xK from the side ODD bracket and remove it
Optical Disk Drive
To remove the optical disk drive, follow the steps below
3. Remove the screws 2xK from the rear ODD bracket and remove it
Fig. 23 The bottom base assembly
Bottom Base Assembly
Disassemble the bottom base assembly as follows
1. First remove the screws 4XA from the top cover
Main Board Assembly
8. Take away the main board
12. Push out the touchpad assembly
Fig. 27 The touch pad connector
9. Partially remove the foil over the touchpad
EasyNote W7 Dragon SN Disassembly Manual