Manuals / Packard Bell / Computer Equipment / Laptop

Packard Bell W7 manual Waarschuwing, Avvertenza

Models: W7

1 18

Page 5

WAARSCHUWING

Zorg er voor dat alle verbindingen van en naar de computer (stroom, modem, netwerk, etc) verbroken worden voordat de behuizing geopend wordt. Zet de computer nooit aan als de behuizing geopend is.

AVVERTENZA

Prima di rimuovere il coperchio del telaio, assicurarsi che il sistema sia scollegato dall’alimentazione, da tutti i collegamenti di comunicazione, reti o linee di modem. Non avviare il sistema senza aver prima messo a posto il coperchio.

Page 5

Image 5

Packard Bell W7 manual Waarschuwing, Avvertenza

Contents

Packard Bell EasyNote W7 Series Dragon SN Disassembly Manual Table of Contents Reassembly Instructions Disassembly InstructionsOverview Required ToolsHazardous Voltage Power Supply UnitAvoid Electrostatic Discharge WARNUNGAVVERTENZA WAARSCHUWINGRemoving the Hard Disk Drive Battery and AC AdapterBottom Panel CPU, VGA Module and Heat Sink Top Cover 9. Remove the screw 1xD and remove the lid switch unit 8. Disconnect the lid switch connectorFig. 11 Disconnecting touchpad flat cable Fig. 13 Lid switch and hingesDisassembling the LCD Panel Assembly Removing the LCD Panel Assembly11. Remove the lower supporting bracket 10. Disconnect the inverter backlight connector12. Take away the LCD display panel and inverter board 13. Disconnect the LCD cable from the inverter boardFig. 18 LCD display cable Fig. 19 Wireless antennaTo remove the optical disk drive, follow the steps below Optical Disk Drive2. Remove the screws 2xK from the side ODD bracket and remove it 3. Remove the screws 2xK from the rear ODD bracket and remove itDisassemble the bottom base assembly as follows Bottom Base AssemblyFig. 23 The bottom base assembly 1. First remove the screws 4XA from the top coverMain Board Assembly Fig. 27 The touch pad connector 12. Push out the touchpad assembly8. Take away the main board 9. Partially remove the foil over the touchpadEasyNote W7 Dragon SN Disassembly Manual