Packard Bell W7 manual Overview, Disassembly Instructions, Reassembly Instructions, Required Tools

1

Overview

This document contains step-by-step disassembly instructions for the EasyNote W7 (Dragon SN) chassis. The instructions are illustrated where necessary with images of the part that is being removed or disassembled.

Packard Bell reserves the right to make changes to the chassis without notice.

Disassembly Instructions

When disassembling the system unit, follow these general rules:

nTurn off the power.

nDisconnect the AC adapter.

nRemove the battery.

nDo not disassemble the system into parts that are smaller than those specified in the instructions.

nLabel all removed connectors; note where the connector goes and in what position it was installed.

Reassembly Instructions

Reassembly is the reverse of the disassembly process. Use care to ensure that all cables and screws are returned to their proper positions. Check that no tools or any loose parts have been left inside the chassis. Check that everything is properly installed and tightened.

Required Tools

All disassembly procedures can be performed using the following tools:

nPhilips (#2 bit) screwdriver

nHex bolt screwdriver