Packard Bell W7 manual Bottom Panel

Models: W7

1 18

Page 7

Fig. 3 Removing the hard disk drive.

Perform the following steps to remove the bottom panel:

1. Remove nine screws (9xA) and take away the bottom panel.

Fig. 4 Removing the bottom panel.

2.Remove the memory module.

3.Lift out the TV Tuner Mini-PCI card from its slot.

4.Disconnect the antenna cable and the two data cables.

5.Disconnect the TV Tuner data cables from the mainboard.

6.Remove the Mini-PCI Wireless LAN card and disconnect the antenna cable(s).

Image 7

Contents

Packard Bell EasyNote W7 Series Dragon SN Disassembly Manual Table of Contents Required Tools Disassembly InstructionsReassembly Instructions OverviewWARNUNG Power Supply UnitHazardous Voltage Avoid Electrostatic DischargeAVVERTENZA WAARSCHUWINGRemoving the Hard Disk Drive Battery and AC AdapterBottom Panel CPU, VGA Module and Heat Sink Top Cover Fig. 13 Lid switch and hinges 8. Disconnect the lid switch connector9. Remove the screw 1xD and remove the lid switch unit Fig. 11 Disconnecting touchpad flat cableDisassembling the LCD Panel Assembly Removing the LCD Panel Assembly13. Disconnect the LCD cable from the inverter board 10. Disconnect the inverter backlight connector11. Remove the lower supporting bracket 12. Take away the LCD display panel and inverter boardFig. 18 LCD display cable Fig. 19 Wireless antenna3. Remove the screws 2xK from the rear ODD bracket and remove it Optical Disk DriveTo remove the optical disk drive, follow the steps below 2. Remove the screws 2xK from the side ODD bracket and remove it1. First remove the screws 4XA from the top cover Bottom Base AssemblyDisassemble the bottom base assembly as follows Fig. 23 The bottom base assemblyMain Board Assembly 9. Partially remove the foil over the touchpad 12. Push out the touchpad assemblyFig. 27 The touch pad connector 8. Take away the main boardEasyNote W7 Dragon SN Disassembly Manual