Others

Problem

Check points

 

This unit cannot be

≥Press the RESET button. (l115) If normal conditions are not

 

operated though

restored yet, remove the battery or AC adaptor, wait about 1 minute

powered up.

and then reconnect the battery or AC adaptor. Then about 1 minute

 

This unit does not

later, turn on the power again. (Conducting the above operation

 

while the card is being accessed may damage the data on the

 

operate normally.

SD card.)

 

The remote control does

≥Does the grip belt not hide the remote controller receiver sensor?

 

not function.

# Please take care so that the grip belt does not hide the remote

 

 

controller receiver sensor.

 

 

≥Has the button-type battery of the remote control run out?

 

 

# Replace it with a new button-type battery. (l25)

 

A function indication

≥If you set [SETUP] > [DISPLAY] > [OFF], indications other than

 

such as the remaining

warnings and date indications disappear.

 

time indication or the

 

 

elapsed time indication is

 

 

not shown.

 

 

Recording does not start

≥Has the SD card’s write protect switch been set to LOCK?

 

although power is

# No recording is possible while the write protect switch is set to

 

supplied to this unit and

LOCK. (l28)

 

the SD card is correctly

≥Is the memory of the SD card full?

 

inserted.

# If there is no more available memory, free up some memory by

 

 

deleting unnecessary scenes or use a new SD card. (l34, 73,

 

 

75)

 

 

≥Is the unit set to recording mode?

 

 

# No recording is possible if the mode dial is set to other than

.

 

≥Is the card slot cover open?

 

 

# If the card slot cover is open, this unit may not operate normally.

 

 

Close the card slot cover.

 

The unit arbitrarily stops

≥Can the SD card be used for motion picture recording?

 

recording.

# Use an SD card that can be used for motion picture recording.

 

 

(l27)

 

 

 

 

112