Before using

Tripod receptacle

The tripod receptacle is a hole used to mount a tripod for the unit. (For details on mounting the tripod, refer to the operating instructions for the tripod.)

≥Responsible for the ISO 1222 (1/4 inch)

≥The tripod mounting hole is 5.5 mm deep. Do not force the tripod screw beyond this depth.You can damage the camera-recorder if you use any screw other than 1/4-20UNC.







ACamera base

BScrew for mounting the unit C Tripod pin

≥You can perform operations easily using the remote control when the tripod is used. (l25)

Lens Hood PieceªInstalling the lens hood

Tighten (loosen) the lens hood screw A to install (remove) the lens hood.

ªInstalling the lens hood piece

Rotate the lens hood piece counter-clockwise A to remove it. In order to attach it, place into slot B, and then rotate it clockwise C.

  

≥Install the ND filter or the MC protector of the Filter kit VW-LF43N (optional) on the front side of the lens hood piece. Do not install anything else (except for the lens cap). (For details, refer to the operation manual of the filter kit.)

≥Install the tele-conversion lens VW-T4314H (optional) or the wide-conversion lens VW-W4307H (optional) after removing the lens hood piece. (Do not install it on the front side of the lens hood piece.) (For details, refer to the operation manual of the tele-conversion lens/ wide-conversion lens.)

≥It is possible to install the ND filter and the tele-conversion lens one over the other. However, when the zoom is set to W, four corners on the screen may be darker (vignetting), thus it is not recommended.

23