Recording

Use the external microphone or audio devices connected to the XLR terminal.

1Connect the external microphone or an audio device to the XLR CH1/CH2 terminal (XLR 3-pin)

CH1 CH2



A An external microphone or an audio device

2Switch the connected audio input signal using the input level select switch



AMicrophone attenuation switch BInput level select switch LINE:Select when an audio device is

connected.

≥The input level is 0 dBu.

MIC:The ALC (Auto Level Control) function is disabled. The audio recording level can be adjusted with the AUDIO LEVEL knob.

≥The input level is -50 dBu/-60 dBu. ≥Switch the input level by using the

microphone attenuation switch. When the microphone attenuation switch is turned ON, the input level is -50dBu.

However, when the level is set to OFF,

the sensitivity increases, which may introduce noise into the recording.

3Set the input level select switch to +48V to use a phantom microphone (a microphone that requires the +48V power supply).

+48V:When a phantom microphone is connected

≥+48V power is supplied to the XLR CH1/CH2 terminal.

≥The battery will discharge faster when a phantom microphone is used.

≥When connecting a device that does not support the +48V power supply, set the switch to LINE or MIC. Setting the switch to +48V may cause the connected device to fail.

4Set the CH1 switch to REAR

Audio from the device connected to the XLR CH1 terminal is recorded.

5Set the CH2 switch to REAR

Audio from the device connected to the XLR CH2 terminal is recorded.

4 5

59