Panasonic AG-HMX100E, AG-HMX100P WHT, 00 E, 2:00 F

Operation Basic

Setting Screen

When setting up this unit or adjusting functions, you need to check the current settings on the LCD screen.

The following shows the basic configuration of the setting screen.

1

2

3

POS. X 128 Y 128

Z 196

FAN STOP

EVENT

ME TIME

PATTERN

INT

00 E

2:00 F

3044

WHT

VIDEO EFFECTS

CH A

MOSAIC

OFF

XY

SIZE

0

DEFOCUS

OFF

LEVEL

0

MONO

OFF

4

5

6

1Joystick, rotary Z control settings, and 3D display area

Shows the setting values of the joystick and rotary Z control; X, Y, and Z values during position setting and

PB, PR, and C GAIN values during color setting.

When this unit is in 3D mode ( page Vol. 2-25), [3D] is displayed.

2Audio level meter

Indicates the audio output level.

3Error Message

An error message appears in the following cases.

Message	Condition and Action
FAN STOP	The fan has stopped from any cause.
	Immediately turn off the power and
	request a service call ( page 39).
CHANGE HDMI	HDMI input source in the format other
FORMAT	than the system formats ( page 19)
CHANGE HDMI1	available for this unit is being
FORMAT	connected to this unit.
CHANGE HDMI2	CHANGE HDMI FORMAT: Input
FORMAT	sources of both HDMI IN
	connectors are in unavailable
	formats.
	CHANGE HDMI1 FORMAT:
	Input source of the HDMI IN 1
	connector is in unavailable format.
	CHANGE HDMI2 FORMAT:
	Input source of the HDMI IN 2
	connector is in unavailable format.
	Change the system format setting or
	the input source setting.

NOTE

The “FAN STOP” error message is also displayed on the multi-view screen. However, since the multi-view screen does not open when this unit is in 3D mode ( page

Vol.2-25), no error message is displayed even if the fan stops. Pay attention to a message which will appear on the LCD.

If two types of errors occur at the same time, “FAN STOP” is displayed preferentially.

4Event number, transition time, pattern number, and internal video display area

EVENT: Shows the event number ( page Vol.2-20).

ME TIME: Shows the setting value of transition time ( page 35); DSK TIME value during downstream key setting ( page 37) and FADE TIME value during fade setting ( page 38).

To change the TIME type, press the applicable transition time setting button (ME, DSK, or FADE) to turn on.

PATTERN: Shows the number of the currently selected pattern ( page 35).

INT: Shows the type of the currently selected internal

(internally generated) video ( page 28).

5Menu title, related information, rotary 1 to 5 parameter display area

Shows the title of the currently selected menu

( page 21) (e.g., VIDEO EFFECTS), bus settings (A/B), related information (color settings, etc), and setting positions of rotary 1 to 5 controls.

20