Panasonic AJ-HD3700B manual ≥50P error status output table

Connector signals

Pin no.	Signal		Direction	Type		Description
16	TC_SOURCE_		INPUT	PULSE SIGNAL	This sets TC SOURCE to EXT and TC SLAVE to ON.
	EXT COMMAND
17	TC_SLAVE_AUTO		INPUT	PULSE SIGNAL	This sets TC SOURCE to INT and TC SLAVE to AUTO.
	COMMAND				During normal recording, the TCG value is recorded.
					During editing, the signal is regenerated at TC on the tape.
18	TL_SLAVE_MUST		INPUT	PULSE SIGNAL	This sets TC SOURCE to INT and TC SLAVE to SLAVE.
	COMMAND				During normal recording and editing, the signal is
					regenerated at TC on the tape.
19	TC_RESET		INPUT	PULSE SIGNAL	This clears the TCG value to zero.
	COMMAND
20	STBY ON/OFF		INPUT	PULSE SIGNAL	This sets the toggling action below. However, it takes
	COMMAND				effect in the STOP mode or STANDBY OFF mode.
					STANDBY ON () STANDBY OFF
21	ERR O STATUS		OUTPUT	SIGNAL	Refer to the 50P error status output table below. (This pin
					is related with pins 24 and 34.)
22	SPARE		INPUT		Spare
23	CUE COMMAND		INPUT	PULSE SIGNAL	When this has become active, the tape is prerolled from
					the cue-up point on the VTR’s menu.
					When the VTR has opened the AUTO EDIT menu:
					≥The tape is prerolled from the time for the IN point when
					the AUTO EDIT menu IN point has been entered.
					≥The tape is prerolled from the time for the current
					position when the AUTO EDIT menu IN point has not
					been entered.
					When the VTR has opened a menu other than the ones
					above:
					≥The tape is prerolled from the time for the CUE TIME
					when CUE TIME of the HOME menu has been entered.
					≥The tape is prerolled from the time for current position
					when the CUE TIME of the HOME menu has not been
					entered.
24	ERR 1 STATUS		OUTPUT	SIGNAL	Refer to the 50P error status output table below. (This pin
					is related with pins 21 and 34.)
25	SPARE		INPUT		Spare
26	i15 V POWER		OUTPUT		i15 V power
27	REC STATUS		OUTPUT	ACTIVE_L	This becomes active when the VTR is in the REC mode. It
					also becomes active when the REC button lamp on the
					front panel is lighted.
28	PLAY STATUS		OUTPUT	ACTIVE_L	This becomes active when the VTR is in the PLAY mode.
					It also becomes active when the PLAY button lamp on the
					front panel is lighted.
≥50P error status output table
Output priority		Pin 21		Pin 24	Pin 34	VTR status
sequence		ERR 0		ERR 1	ERR 2
	1	0		0	0	NO SERVO LOCK
	6	0		0	1	SERVO LOCK
	5	0		1	0	HIGH ERROR
	4	0		1	1	CONCEAL/V
	3	1		0	0	CONCEAL/A
	2	1		0	1	CONCEAL/VA
––––		1		1	0
––––		1		1	1

– 46 –