Panasonic AK-HRP200G Setup mode (continued), „„Basic operations, „„Opening setup mode, „„Exiting setup mode, 1.Selects set values, 6.Confirms a setting, 4.Indicates menu numbers

Setup mode  (continued)

„„Opening setup mode

Setup mode differs from normal operating modes. Use the steps below to open setup mode.

1.When a camera and CCU are connected, select IRIS (to light the <IRIS> display on the panel).

If the IRIS display is not lit, press the selected <DISPLAY SELECT> button to select IRIS.

UP	ND	CC	SHT	SYNC	CAMERA
	M.GAIN		M.PED		10-19
DATA
SET
			IRIS		No.
DOWN	DISPLAY SELECT				SELECT
SET UP	ND/CC	M.GAIN/M.PED SHUTTER
SHIFT
+	SAVE/LOAD		EXIT	EXECUTE
UP+DOWN

IRIS display

Use the steps below to open setup mode when the power is on, but a camera or CCU is not connected.

2.Simultaneously hold down DATA SET <DATA SET> <UP>, <DOWN> and <SHIFT> for approximately two seconds.

This opens setup mode and Menu No. 1 (camera number setting) is

displayed.

SCENE/USER FILE

SHIFT	SCENE 1	SCENE 2		SCENE 3	SCENE 4 STORE
	USER 1	USER 2		USER 3
UP	ND	CC	SHT	SYNC	CAMERA
	M.GAIN		M.PED		10-19
DATA
SET
			IRIS		No.
DOWN	DISPLAY SELECT				SELECT
SET UP	ND/CC	M.GAIN/M.PED SHUTTER
SHIFT
+	SAVE/LOAD		EXIT	EXECUTE
UP+DOWN

„„Exiting setup mode

To exit setup mode, hold down <EXIT> for two seconds. The unit returns to normal operating mode.

UP	ND	CC	SHT	SYNC	CAMERA
	M.GAIN		M.PED		10-19
DATA
SET
			IRIS		No.
DOWN	DISPLAY SELECT				SELECT
SET UP	ND/CC	M.GAIN/M.PED SHUTTER
SHIFT
+	SAVE/LOAD		EXIT	EXECUTE
UP+DOWN

„„Basic operations

The buttons indicated in the figure below are available in setup mode. No other buttons are available. All other LEDs stay off. (Except the alarm display)

1		2		3	4
UP	ND	CC	SHT	SYNC	CAMERA
	M.GAIN		M.PED		10-19
DATA
SET
			IRIS		No.
DOWN	DISPLAY SELECT				SELECT
SET UP	ND/CC	M.GAIN/M.PED SHUTTER
SHIFT
+	SAVE/LOAD		EXIT	EXECUTE
UP+DOWN
	7		8	6	5

1.Selects set values2.Indicates selected submenu3.Indicates set values and selected values4.Indicates menu numbers5.Selects a menu number. Each press of the button increments menu numbers.

1→2→3→...→19→1→2→...

6.Confirms a setting7.Selects a submenu. Each press of the button opens a different submenu.

8.To exit setup mode, hold down <EXIT> for two seconds. The unit returns to normal operating mode.

UP	ND	CC	SHT	SYNC	CAMERA
	M.GAIN		M.PED		10-19
DATA
SET
			IRIS		No.
DOWN	DISPLAY SELECT				SELECT
SET UP	ND/CC	M.GAIN/M.PED SHUTTER
SHIFT
+	SAVE/LOAD		EXIT	EXECUTE
UP+DOWN

5