INSTALLATION OF PAN/TILT HEAD
•Install the pan/tilt head after carefully reading the Operating Instructions for Pan/tilt Head.
•Have four hex bolts (M6 x 4) ready for mounting the pan/title head. Select bolts of a length appropriate to the material and structure of the mounting base and the overall weight applied to it. Fasten the bolts securely with plain washers, spring washers, and hex nuts. If the bolts are not securely tightened, the pan/tilt head might fall to cause injuries or accidents. In case of sus- pending the pan/tilt head, locally purchase a wire rod strong enough to hold the pan/tilt head, camera, and lenses, pass it through the wire hole opened in a firm board, such as of the ceiling, for example, and fasten it securely.
•The switches on the pan/tilt head have been preset before shipment from the factory on the assumption that the pan/tilt head would be suspended from the ceiling. If the pan/tilt head is mounted on a board, for example, be sure to shift the mounting direction switch- es on the pan/tilt head. Unless this is done, pan/tilt directions will be reversed and pan/head operation lim- iter data cannot be properly stored in the memory. For details on shifting these switches, refer to the Operating Instructions for Pan/tilt Head.
Have a strong enough wire rod head and fasten it securely to a firm board, such as of the ceiling.
