2)Adjust the cable compensation, genlock, and total pedestal of the selected camera.
•Cable Compensation
Signal degradation due to cable length between the con- trol panel and the pan/tilt head can be compensated for.
qIf the cable length from the pan/tilt head to the control panel is longer than 300 meters, set the cable com- pensation switch on the pan/tilt head to the ON posi- tion. For details, refer to INSTALLATION OF PAN/TILT HEAD at page 8 or the Operating Instructions for Pan/tilt Head.
wConnect a waveform monitor or a vectorscope to the video output connector on the control panel for the corresponding the camera pan/tilt head number ([1] to [5]), set the video output connector on the control panel, set the mode switch to the BAR position, then observe the color bar signals.
eAdjust the Y (luminance) signal level with the CABLE COMP Y control for the corresponding camera pan/tilt head number ([1] to [5]), then adjust the CABLE COMP Y control then adjust the C (chrominance) sig- nal level with CABLE COMP C control. Repeat this until the video output of the control panel is adjusted as shown in the figure below.
Note: Turning CABLE COMP Y control changes not only the Y (luminance) signal level but also the video signal levels as a whole.
CABLE COMP Y Control
Multiport Hub
1 | C A B L E | 3 | C O M P | 5 |
2 | 4 |
| P O W E R |
|
|
|
|
|
|
|
|
|
O F F | O N |
|
|
|
|
|
|
|
|
|
| Y | C | Y | C | Y | C | Y | C | Y | C |
M u l t l P o r t H u b A W - H 8 5 0 5
CABLE COMP C Control
Waveform Monitor | Color Monitor |
Vector Scope | (75Ω termination) |