Operating Instructions
36
Basic
(1) Network (IPv4) Configures the IPv4 network settings to connect the
camera to the network (see page 38).
(2) Network (IPv6) Configures the IPv6 network settings to connect the
camera to the network (see page 43).
(3) IPsec Enables IPsec (Transport or Tunnel mode) (see page
47).
(4) UPnP Enables automatic port forwarding and creates a
shortcut to the camera (see page 57).
(5) DynamicDNS Registers with a DNS service, such as Viewnetcam.com
service (see page 60).
(6) Date and Time Sets the date and time, automatic time adjustment and
daylight saving time settings (see page 67).
(7) Camera Sets camera name, white balance and color night view
(see page 70).
(8) Audio Sets output, volume, PC audio input timeout, input,
camera microphone sensitivity and mute during tilt
settings (see page 73).
Account
(9) Administrator
*1 Sets authentication and administrator security (user
name and password) (see page 75).
(10) General User*1 Sets general user security (user name and password)
and access levels (see page 80).
Buffer/Transfer
(11) Trigger Sets image buffer or transfer by timer, alarm, or motion
detection (see page 84, page 94, or page 106).
(12) Motion
Detection Sets the threshold and sensitivity for motion detection
(see page 120).
(13) Alarm Log Sets the information required to send log notifications by
e-mail (see page 124).
Advanced
(14) Image Display Sets the resolution, image quality and refresh interval of
the Single Camera and Multi-Camera page, as well as
time stamp setting, language and banner (see page
132).
(15) Multi-Camera*1 Sets the camera IP address or host name, and camera
name on the Multi-Camera page (maximum 12
cameras) (see page 135).