Operating Instructions
94
4.3 Buffering or Transferring Images by Alarm Signal
You can buffer the camera images, transfer to an FTP server or send E-mails using
alarm as a trigger.
The Trigger page allows you to enable image buffer/transfer by E-mail or FTP.
Note
• If you are recording images to the SD memory card, refresh interval slows
down.
• To buffer/transfer images by alarm signal, an alarm must be connected to the
external I/O (see page 151).
1. Click [Trigger] on the Setup page.
2. Click a No. to enable buffer/transfer.
3. Check [Enable Image Buffer/Transfer], select [Alarm 1 or 2] for the trigger,
select [Rising: GND to Open (High).] or [Falling: Open (High) to GND.] and
click [Next>].
• Click [Delete Buffered Images] to delete images already buffered.
• Click [Save] to save the settings.
• Clicking [Cancel] takes you back to the Trigger page without saving
changes.
Note
• If you click [Save], all buffered images on the internal memory and SD
memory card are deleted.