Operating Instructions
45
Setting Description
Allow Access from
the Internet • If [Yes] is selected for Allow Access from the Internet,
you can access the camera from the Internet. If [No] is
selected, the camera can be accessed only from a LAN
that has an same IPv6 prefix as the camera.
Port N umber (Stat ic
Only) • The default port number is 80. A un ique port number
must be set for each terminal on your network.
• Do not set the following port numbers.
FTP: 20 and 21, Telnet: 23, SMTP: 25, DNS: 53,
POP3: 110, HTTPS: 443, ICQ: 4000 and IRC: 6661—
6667.
• Enter a number between 1—65535.
• Some ISPs do not allow you to use port 80. Ask your
ISP or network administrator about which port
numbers are accessible over the Internet.
IP address
(Static Only) • Enter a global address. You do not need to enter a
prefix length.
• An IPv6 address consists of 8 hexadecimal numbers
divided by ":". Consecutive 0s can be abbreviated as
"::". (E.g. 2001:2:3:4::5)
Default Gateway
(Static Only) • If you have been assigned a Default Gateway IPv6
address by your ISP or network administrator, enter it
in this data field.
• An IPv6 address consists of 8 hexadecimal numbers
divided by ":". Consecutive 0s can be abbreviated as
"::". (E.g. 2001:2:3:4::5)
DNS Server
Address • The DNS server address is required in the following
situations:
– Transferring camera images by E–mail or FTP
– Setting cameras by their host names on the
Multi-Camera Setup page
– Using the DynamicDNS service
– Using the alarm log notification
• If you have been assigned a DNS server IPv6
addresses by your ISP or network administrator, enter
them in this data field. Ther e are usually two
addresses.
• An IPv6 address consists of 8 hexadecimal numbers
divided by ":". Consecutive 0s can be abbreviated as
"::".
(E.g. 2001:2:3:4::5)