How to Use the On Screen Menu
The screen displays eight types of information: input signal status, picture adjusting knob status, sharpness display, FUNCTION display, audio level meter display, menu display, time code display and closed caption display.
Input signal status
1. The selected input line (J page 9, 
)
• VIDEO, SDI1, SDI2,
2. Signal format
• Use “STATUS DISPLAY” in the “SYSTEM CONFIG” menu to set the display status (J page 22).
• “UNSUPPORT SIGNAL” appears if an unsupported signal is input. It may also indicate that the format selected in the “INPUT SELECT” menu does not match the input signal.
• “NO SIGNAL” appears if no signal is input.
3. Various indications (PIXEL TO PIXEL mode)
• This indicates the PIXEL TO PIXEL mode is engaged.
4. Various indications (FILM mode)
• This indicates that “GAMMA SELECT” is set to “FILM.”
5. Various indications (lock status)
• This indicates that the control lock is on.
Note:
“UNSUPPORT SIGNAL” and “NO SIGNAL” may not be properly displayed.
Picture adjusting knob status
Picture adjusting knob (J page 9, 
)
• Press or turn this knob to make adjustments.
• The status display appears when the knob is pressed. To clear the display, press the knob again or leave it idle for 10 seconds.
• Only adjustments that appear on the screen can be adjusted.
• The display always appears in the same screen location.
Display status:
PHASE, CHROMA, BRIGHT, CONTRAST or BACKLIGHT.
Note:
The status of the volume knob does not appear on the screen.
Sharpness display
• This is the SHARPNESS H/V mode display.
• It disappears after 2 minutes of inaction.
12