Read Me First

For U.S.A.

Federal Communications Commission Radio Frequency Interference Statement

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the Panasonic Service Center or an experienced ra- dio/TV technician for help.

Warning

To assure continued compliance, use only shielded interface cables when connecting to a computer or peripheral. Also, any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

FCC RF Exposure Warning:

This equipment is provided with PC Card slot that could be used with wireless transmitters, which will be specifically recommended when they become available.

Other third-party wireless transmitters have not been RF ex- posure evaluated for use with this computer and may not comply with FCC RF exposure requirements.

<Only for models with wireless LAN>

This equipment complies with FCC radiation exposure lim- its set forth for an uncontrolled environment.

This equipment has been approved for mobile operation, and unless otherwise advised in separate supplemental instruc- tions for individual wireless transmitter(s), requires mini- mum 20 cm spacing be provided between antenna(s) and all person’s body (excluding extremities of hands, wrist and feet) during wireless modes of operation.

This equipment may use multiple installed transmitters, which may be capable of simultaneous transmission.

<Only for models with wireless LAN>

This product is restricted to indoor use due to its operation in the 5.15 to 5.25 GHz frequency range.

FCC requires this product to be used indoors for the frequency range 5.15 to 5.25 GHz to reduce the potential for harmful interference to co-channel Mobile Satellite systems.

High power radars are allocated as primary users of the 5.25 to

5.35GHz and 5.65 to 5.85 GHz bands. These radar stations can cause interference with and /or damage this product.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2)This device must accept any interference received, including interference that may cause undesired operation.

Responsible Party: Panasonic Corporation of North America

One Panasonic Way

Secaucus, NJ 07094

Tel No:1-800-LAPTOP5 (1-800-527-8675)

FCC Regulation Notice for modem

Started

 

This equipment contains a FCC approved modem.

 

Tested To Comply

Getting

With FCC Standards

 

FOR HOME OR OFFICE USE

 

1. This equipment complies with CFR47 Part 68 rules. On the

 

computer is a label that contains, among other information,

 

the FCC registration number and ringer equivalence number

 

(REN) for this equipment. If required, this information must

 

be provided to the telephone company.

 

2. An FCC compliant telephone cord and modular plug is pro-

 

vided with this equipment. This equipment is designed to be

 

connected to the telephone network or premises wiring us-

 

ing a compatible modular jack which is Part 68 compliant.

 

See Installation Instructions for details.

 

3. The REN is used to determine the quantity of devices which

 

may be connected to the telephone line. Excessive RENs on the

 

telephone line may result in the devices not ringing in response

 

to an incoming call. In most, but not all area, the sum of RENs

 

should not exceed five (5.0). To be certain of the number of

 

devices that may be connected to a line, as determined by the

 

total RENs, contact the local telephone company.

 

4. If your telephone equipment cause harm to the telephone net-

 

work, the telephone company will notify you in advice that

 

temporary discontinuance of service may be required. But if

 

advice notice isn’t practical, the telephone company will no-

 

tify the customer as soon as possible. Also, you will be ad-

 

vised of your right to file a complaint with the FCC if you

 

believe it is necessary.

 

5. The telephone company may take changes in its facilities,

 

equipment, operations or procedures that could affect the op-

 

eration of the equipment. If this happens the telephone com-

 

pany will provide advance notice in order for you to make

 

necessary modifications to maintain uninterrupted service.

 

6. If trouble is experienced with this equipment, for repair or

 

warranty information, please contact Panasonic Corporation

 

of North America at DIAL TOLL FREE 1-800-LAPTOP5

 

(1-800-527-8675). If the equipment is causing harm to the

 

telephone network, the telephone company may request that

 

you disconnect the equipment until the problem is resolved.

 

7. There are no user serviceable parts contained in this equip-

 

ment.

 

8. This equipment may not be used on coin service provided by

 

the telephone company. Connection to party lines is subject

 

to state tariffs.

 

3

Page 3
Image 3
Panasonic CF-73 Series appendix Read Me First, For U.S.A, FCC Regulation Notice for modem