Position, Image, Auto Center, Phase, Clock

(Position)

Image Position

H-Position

V-Position

Auto Center

(Image)

Image

Phase

Clock

Auto Phase

The Position menu allows the adjustment of image po- sition in Analog input mode.

Select the item by pressingor, then press .

H-Position

H-position is used to adjust the horizontal image posi- tion manually. A slider and the current value are dis- played. The adjustment range is 0 to 127.

Adjust by pressingor, then press . (To cancel, press and then turn off the power to the LCD Monitor. When the power is turned on again, the operation will be canceled.)


V-Position
V-position is used to adjust the vertical image position
manually. A slider and the current value are displayed.
The maximum value for Vertical Position is to 1 to 47.
The maximum value for Vertical Position is to 1 to 47.			E
(Depending on the RGB input signal, the upper value			E
of this range may be below 47.)
of this range may be below 47.)
Adjust by pressing or , then press . (To cancel,
press	and then turn off the power to the LCD Moni-
tor. When the power is turned on again, the operation
will be canceled.)
Auto Center
A confirmation box is displayed. The default selection
A confirmation box is displayed. The default selection
is [Yes]. Press		to adjust the position automatically.

If you want to cancel, select [No] and press .

To save the adjusted value, select [H-Position] or [V- Position], then press .

The image menu allows the adjustment of ADC clock and phase in Analog input mode.

Select the item by pressing or , then press .

Phase

Phase adjustment is used to adjust the phase of ADC sample pixel clock. A slider and the current value are displayed. The adjustment range is 1 to 31, representing 0-360 degrees. Adjust by pressing or, then press . (To cancel, press and then turn off the power to the LCD Monitor. When the power is turned on again, the operation will be canceled.)