Panasonic CF-VDL02BM General Events, Windows, Devices Calibration, Hardware, Settings, Status

Configuring the Touchscreen

When needed, the touchscreen can be configured using the following steps.

1Windows XP

Select from the taskbar and select [Adjust settings], or select [Settings] from [start] - [All Programs] - [UPDD]

Windows 2000

Select from the taskbar and select [Adjust settings], or select [Settings] from [Start] - [Programs] - [UPDD]

The following screen will be displayed.

	General
Events	Set the general settings and functions.
					E
Set the events that can	Windows
be generated by a controller.	Set the “double-click” settings.
Devices			Calibration
Configure			Define the calibration setup.
the device controller.			Use when the cursor can not
Hardware			be pointed correctly with the
			finger or stylus. (Needed if
Set the hardware			the alignment of	the
resources. Make			touchscreen with the visual
sure that this set-			image change or adjust the
ting matches the			display resolution).
[Serial Port] to			<Only for CF-M34 series
which the LCD			models other than the CF-
monitor has been			M34C******>
connected as set			Before you run the calibra-
using the Setup			tion, you need to set the de-
Utility.			vice at [Calibration Settings
			For] as followings.
Settings			[Device 1] is for the com-
			puter
Set the general protocol
			[Device 2] is for the LCD
settings.
			Monitor
Advanced
			About
Set the advanced settings.
			Display the version number.
NOTE		Status
For more information, refer to [Help].		Display the status of the controller.

11