20
Alarm Setting
DISPDISP
Alarm time setting
1 Hold down [ALM] (Alarm) for more than 2
seconds.
(Alarm time
display)
“ALM ADJ” is displayed when the alarm time is
not adjusted.
2 Hold down [ALM] for more than 2 seconds
after the above display is shown.
Hour blinks
3 Adjust the hour.
[d] : Sets ahead.
[s] : Sets back.
Hour entered
4 Push [ALM].
Minute blinks
5 Adjust the minute.
[d] : Sets ahead.
[s] : Sets back.
Minute entered
6 Push [ALM] to complete.
Completed
The alarm is set to ON automatically after com-
plete alarm time setting.
Alarm indicator ( ) lights.
Notes:
¡ The procedure of alarm time setting under Siri-
usXM radio mode is different with above step 1,
refer page 18 for its instructions.
¡ When the clock (a page 9) is not set, perform
and complete the alarm time setting, the clock
time will set to “PM 1:00” automatically. Please
readjust the clock time depending on the actual
clock time.
¡ Hold down [d] or [s] to change numbers
rapidly.
¡ When you want to readjust the alarm time, repeat
steps 1 to 6.
Turning ON/OFF the alarm
1 Hold down [ALM] for more than 2 sec-
onds.
(Alarm time
display)
2 Push [ALM].
(Alarm ON/OFF
setting)
3 Turn [VOL] (Volume) clockwise or counter-
clockwise to select alarm ON or OFF, then
push [ALM] again to confi rm the setting.
(Select alarm ON, lights.)
Notes:
¡ Before turn ON the alarm, make sure the alarm
time is set. Failure to heed this will cause invalid
selection of alarm ON.
¡ Hold down [ALM] for more than 2 seconds when
the alarm is sounding also turns off the alarm.
¡ Access of alarm ON/OFF is available by push
[ALM] in the “Alarm time display”.
Activating snooze
Press any button on this unit when the alarm
is sounding.
The alarm will sound again in 9 minutes.
Note: If you do not turn the alarm off when the
alarm is sounding, the alarm sound will shut off af-
ter an hour. (Including the amount of time the alarm
was postponed (snooze))
[ALM]
[VOL]
[s]/[d]