Panasonic CQ-5109U operating instructions Observe the following cautions when using this unit

Caution

Observe the following cautions when using this unit.

qKeep the sound volume at an appropriate

level.

Keep the volume level low enough to be aware of road and traffic conditions while driving.

qDo not insert or allow your hand or fingers to

be caught in the unit.

To prevent injury, do not get your hand or fingers caught in moving parts or in the disc slot. Especially watch out for infants.

qThis unit is designed for use exclusively in automobiles.

qDo not operate the unit for a prolonged period

with the engine turned off.

Operating the audio system for a long period of time with the engine turned off will drain the battery.

qDo not expose the unit to direct sunlight or

excessive heat.

Otherwise these will raise the interior temperature of the unit, and it may lead to smoke, fire, or other damage to the unit.

qTo ensure safety, never attempt to preset sta- tions while you are driving.

qDepending upon the transmission condition of electro-magnetic waves, the geographical reasons and/or the weather conditions, you may not receive the NOAA radio partially or at all.

qMake sure that your weather radio can receive properly before driving, especially, before use in a critical condition.

qSet the volume level to low enough before the

AUX connection is completed.

Failure to observe this, the loud noise may come out and damage your speakers and your hearing. Direct con- nection of the speaker/headphone output of an external device without any attenuator may distort sound or dam- age the connected external device.

Observe the following cautions when in- stalling.

qRefer wiring and installation to qualified

service personnel.

Installation of this unit requires special skills and experi- ence. For maximum safety, have it installed by your dealer or an authorized Panasonic Servicenter. Panasonic is not liable for any problems resulting from your own installa- tion of the unit.

qFollow the instruction to install and wire the

product.

Not following the instructions to properly install and wire the product could cause an accident or fire.

qTake care not to damage the leads.

When wiring, take care not to damage the leads. Prevent them from getting caught in the vehicle chassis, screws, and moving parts such as seat rails. Do not scratch, pull, bend or twist the leads. Do not run them near heat sources or place heavy objects on them. If leads must be run over sharp metal edges, protect the leads by winding them with vinyl tape or similar protection.

qUse the designated parts and tools for instal-

lation.

Use the supplied or designated parts and appropriate tools to install the product. The use of parts other than those supplied or designated may result in internal dam- age to the unit. Faulty installation may lead to an accident, a malfunction or fire.

qDo not block the air vent or the cooling plate

of the unit.

Blocking these parts will cause the interior of the unit to overheat and will result in fire or other damage.

qDo not install the product where it is exposed

to strong vibrations or is unstable.

Avoid slanted or strongly curved surfaces for installation. If the installation is not stable, the unit may fall down while driving and this can lead to an accident or injury.

qInstallation Angle

The product should be installed in a horizontal position with the front end up at a convenient angle, but not more than 30˚.

The user should bear in mind that in some areas there may be restrictions on how and where this unit must be installed. Consult your dealer for further details.

qWear gloves for safety. Make sure that wiring is completed before installation.

qTo prevent damage to the unit, do not connect the power connector until the whole wiring is completed.

qDo not connect more than one speaker to one set of speaker leads. (except for connecting to a tweeter)

3