Panasonic CQ-C300U warranty Remote Control Preparation, Clock Adjustment

Set your car’s ignition switch to the ACC or ON position.

Preparation

Cancellation of Demonstration

The demonstration message appears for initial use.

1

2 Press [PWR] (Power).

3 Hold down [VOL] (PUSH SEL: Select) for 2 sec. or more to open the menu.

4 Press [VOL] (PUSH SEL: Select) to

select the Demonstration setting.

(“DEMO” is displayed)

5 Turn [VOL] counterclockwise.

For using the remote control, press [0] ().

Notes:

•To return to the regular mode, press [DISP].

•Refer to the section on “Function Setting” ( page 23).

•When “NO DISC” is displayed, the Demonstration cannot be cancelled.

Remote Control Preparation

Preparation Before Initial Use			Warning
Pull the insulation film
			Keep batteries and insulation film out of reach of
out from the backside of
			infants. If an infant ingests a battery, please seek
remote control gently.
			immediate medical attention.
	Insulation film		Cautions
Battery Replacement			• Remove and dispose of an old battery immediately.
			• Do not disassemble, heat or short a battery. Do not
Remove the battery	Tough pointed object		throw a battery into a fire or water.
			• Follow local regulations when disposing of a
holder with the remote
			battery.
control unit placed on a
			• Improper use of a battery may cause overheating,
flat surface.
			an explosion or ignition, resulting in injury or a fire.
 Stick your thumbnail
into the groove, and
push the holder in			Notice
the direction of the
			This product contains a CR Coin Cell Lithium
arrow, and at the
			Battery which contains Perchlorate Material - special
same time.	Back side
			handling may apply.
 Pull it out in the
			See www.dtsc.ca.gov/hazardouswaste/perchlorate.
direction of the
arrow using a tough	
pointed object.			Note: Battery Information:
 Put a battery in the case			Battery Type: Panasonic lithium battery (CR2025)
with () side facing up.			(Included in the remote control)
 Put the case back.			Battery Life: Approximately 6 months under normal use
			(at room temperature)

Clock Adjustment

The 12-hour system is used for the clock. 1 Press [PWR] (Power).

2 Press [DISP].

3 Hold down [DISP] for 2 sec. or more.

4 Adjust the hour and press [DISP].

[]: Forward

[]: Backward

5 Adjust the minute and press [DISP] to confirm the adjustment.

[]: Forward

[]: Backward

Notes:

•Adjust the clock when “ADJUST” appears on the display.

•Hold down [] or [] to change numbers rapidly.

•When “NO DISC” is displayed, the clock cannot be adjusted.

10CQ-C300U